It is used for roof to wall flashing.
Roof apron flashings.
An apron flashing is responsible for diverting water from a vertical surface into a gutter system.
Finish your roof line and protect the fascia board with the amerimax 10 ft.
Flashings near the edges of roofs or walls can be subjected to suction or negative wind loads that can be greater than other positive imposed loads.
Finish your roof line and protect the fascia board with the amerimax 10 ft.
Apron angle flashings are one piece l shaped flashings usually on the lower side of a chimney.
The extra kick at the bottom of the face directs run off away from the structure.
Placed opposite to base flashing or above base flashing counter flashing completes the two part team.
This drip edge flashing provides protection from water damage along the eaves and rake of a roof.
Protects fascia board finishes the roof line and guides run off into gutters.
Protects fascia board finishes the roof line and guides run off into gutters.
The flashing helps guide run off away from shingles and into the gutters.
They are a combination base and cap flashing that are usually installed behind the siding and caps and over the sloped roofing materials.
30 degree white aluminum.
All roof cladding located at the join except gutters require a flashing fastened on both sides of the join.
The base flashing or apron flashing is the bottom piece.
Step flashing is a rectangular piece of flashing bent 90 degrees in the center.
